WR-01 is an automatic payload replacement device designed for the DJI Airport 3, enabling the use of psdk payloads such as megaphone lighting, gas detection systems, and obstacle avoidance radar.
It allows for remote, one-click installation when required and removal when not needed, saving approximately 10 minutes of flight time. During normal operation, it is stored in the hatch cover without impacting Airport functionality.
Product Introduction
127WR-01 is a load automatic loading and unloading device suitable for DJI Airport 3, which can realize PSD loads such as shouting lighting, gas detection, obstacle avoidance radar, etc,Remote one click installation when in use, removal when not in 7saves about 10 minutes of battery life, stored in the cabin cover for daily use, does not affect normal airport operations.
Ready to use and install Save about 10 minutes of battery life
Airports are deployed in different areas, and it is time-consuming and labor-intensive for people to go there, or there may be situations where people cannot go up at any time due to tower lights, etc. Therefore, the load must be installed on the aircraft when deploying the airport, but many operational tasks do not use it, and it is a waste of endurance to carry the load and fly. By loading and unloading loads, it is possible to save battery life and increase operating radius when not in use
Low frequency usage load No worries about use
For some low-frequency loads, such as obstacle avoidance radar that only plays a value at night or in small obstacles, installing it with low frequency of use and not installing it can be installed and used only in fixed scenarios through the loading and unloading function
Airport operations are not limited by load
Some airports are considering operational scenarios and require mountingGas detection and other non waterproof loads cause the airport to be unable to operate on rainy days, limiting its practicality. Loading and unloading loads can solve the airport’s availability problem